The most common reason a car shuts off while driving is because of a bad crankshaft position sensor or fuel pump. If not, you might need to solder them again.Why Did my Car Shut Off While Driving And Won’t Start? Most Common Reasons A Car Shuts Off While Driving So, you need to make sure that the wires are properly placed. Improper wire connections are a reason why the speakers overheat. The stereo unit draws power and this power draw increases with the volume. Speakers Cut Out Randomly Overheating Of Power Unit If you live near the sea, then corrosion and rusting would be a real issue. Also, the surroundings play an important role as well. This can be caused due to traveling over rough terrain and places. If you suddenly started experiencing issues with the speaker, then the problem might be a damaged wire. As a result, tighten the wires without damaging them. Loose wires will also cause connectivity issues.Īlso, loosely installed wires would also cause connectivity problems. For example, a gauge size of 12 is required for delivering 150 watts of power. If the wire size is quite small, then not enough power will be supplied. Ensure that the gauge connection is of the correct size and connected properly. Problems with the gauge connection might also result in the car speaker turning off and on. The Wires Gauges Are Improperly Installed The better quality materials in the newer models will also help. What you can do is to opt for a better quality amplifier or stereo. The stereo might be able to power up only a certain number of speakers. Sometimes, the problem might be having too many output connections. Speakers Are Cutting Out At A High Volume Cause Having Too Many Output Connections However, if there is no reading, you might have to get a new fuse. If a reading is obtained, then the issue is not a blown fuse. Now, the testing leads should touch against the fuse caps and then record the reading. Use a multimeter set to ohms to check out for a blown fuse. Blown fuses are responsible for irregularities in performance. Another issue is pre-installed fuses in the head units. Poor soldering of the ground connection can severely impact the ability of the amplifier to draw power which might lead to audio cuts. Wires are usually soldered during production. Weak Soldering Of Ground Level Connections and Head Units If budget is not an issue, we would recommend this method. Else, you need either a heavy-duty alternator or battery to keep up with the power requirements. You should try to adjust the frequency and bass settings to lower the power draw. If the value is less than 11.5 volts, then the problem is with the battery. As the current draw stops, the voltage will again rise which will lead to a new cycle.įirstly, use a voltmeter and determine the voltage across the batteries. As the volume level increases, the drain on the speaker also increases and this causes more charge to be drawn eventually causing the stereo to be cut off due to the lack of power. Perhaps the alternator might not be providing sufficient charge to the batteries. If the speaker turns on and off repeatedly then the problem might be with the amplifier or alternator.
0 Comments
Leave a Reply. |